14RQT8881STEP 1 Connection≥Before connection, turn off all equipment and read the appropriate operating instructions.≥Select the connection pattern that matches your environment from pattern A–D. Confirm connections not listed below with your dealer.Make sure to use the pair of supplied RF coaxial cablesUse the pair of supplied RF coaxial cables only when you make connections to the unit through its RF IN and RF OUT terminals. Striping mayappear and disrupt images on the TV if you use different cables for connection.Using a 21-pin Scart cable≥You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (➡ 18).≥You can enjoy high-quality viewing by connecting the unit to an RGB compatible television (➡ 81).[Required]setting] “AV1 Output” in the Setup menu (➡ 65)When the unit is not to be used for a long timeTo save power, unplug it from the household mains socket. This unit consumes a small amount of power, even when it is turned off[approx. 2 W (Power Save mode)]When “Power Save” is set to “On”, the “Quick Start” function does not work.A Connecting a televisionB Connecting a television and VCRRFRFININRFRFOUTOUTAV2 (DECODER/EXT)AV1(TV)OPTICALDIGIDIGITALAL AUDIO OUUDIO OUT(PCM/BITSTREAM)(PCM/BITSTREAM)COMPONENTCOMPONENTVIDEO OUTVIDEO OUT S VIDEOVIDEOR-AUDIO-LPRPBYAC INOUTOUTAAV OUV OUTTVHF/UHFRF IN AV4321 2To the aerial Television’s rear panelAerialcableRF coaxialcable (included)This unit’s rear panelTo household mains socket(AC 220 to 240 V, 50 Hz)Fully wired 21-pinScart cableAC mains lead(included)Connect only after all otherconnections are complete.Cooling fanConnecting a terminal otherthan the 21-pin Scart terminal(➡ 16, 17)RF coaxialcable(included)RFRFININRFRFOUTOUTAV2 (DECODER/EXT)AV1(TV)OPTICALDIGIDIGITALAL AUDIO OUUDIO OUT(PCM/BITSTREAM)(PCM/BITSTREAM)COMPONENTCOMPONENTVIDEO OUTVIDEO OUT S VIDEOVIDEOR-AUDIO-LPRPBYAC INOUTOUTAAV OUV OUTT31AVVHF/UHFRF INVHF/UHFRF INAV OUT5RF OUT6224To the aerialAerial cableCooling fanRF coaxial cable(included)This unit’s rear panelTo household mains socket(AC 220 to 240 V, 50 Hz)Television’s rear panelVCR’srear panelAC mains lead(included)Connect only after all otherconnections are complete.RF coaxial cable(included)Connecting a terminal otherthan the 21-pin Scartterminal (➡ 16, 17)Connect the unit directly to the televisionIf you connect the unit through an AV selectoror video cassette recorder to the television,video signal will be affected by copyrightprotection systems and the picture may notbe shown correctly.Fully wired 21-pinScart cable21-pin ScartcableTelevisionVCRThis unit≥When connecting to a television with a built-in VCRConnect to the input terminals on the television side if there areboth television and VCR input terminals.[Required]setting]“AV2 Input” and “AV2 Connection” settings in the Setupmenu (➡ 66)DO NOT