Panasonic DMR-EX78EB Operating Instructions Manual

Contents

88RQT9078Cannot operate the TV with unit’sremote control. Change the manufacturer code on the remote control. 77 It may be necessary to set the code on the remote control again afterchanging the batteries.86The remote control doesn’t work.  The remote control code is wrong. Change to the correct code. 86 The batteries are depleted. Replace them with new ones. 7 Point the remote control at the remote control sensor on the main unit. 7 Remove obstacles between the remote control and the main unit. − Remove dust from the transmission window and the unit’s sensor. − Coloured glass may obstruct the signal reception/transmission. − Don’t place the signal sensor in direct sunlight or in areas that may besubject to sun exposure.− It may be necessary to set the manufacturer code again after changing thebatteries.77 The Child Lock function is activated. 77The unit is on but cannot beoperated. Recording drive or playback drive has not been selected properly. 20, 21 Some operations may be prohibited by the disc. − The unit is warm (“U59” appears on the unit’s display). Wait until “U59”disappears.84 One of the unit’s safety devices may have been activated.Reset the unit as follows:Press [/I] on the main unit to switch to standby mode,If the unit doesn’t switch to standby mode, reset the unit (¼ 86, “To restorethe unit if it freezes”). The unit cannot be operated while performing an update. “SW-DL” appearson the unit’s display while it is updating. Please wait until the “SW-DL”disappears.−76“U88” is displayed and the disccannot be ejected. The unit is carrying out the recovery process. The disc may be defective.Do the following to eject the disc. Try another disc.(1) Press [/I] on the main unit to switch to standby mode.If the unit doesn’t switch to standby mode, reset the unit (¼ 86, “Torestore the unit if it freezes”).(2) While the unit is turned off, press and hold [] and [CH ] on the mainunit at the same time for about 5 seconds. (Ejection may take extratime depending on discs.)−Cannot eject a disc.  The unit is recording. − The unit may have a problem. Eject the disc as in (2) above. Linked timer recordings with external equipment is in recording standby(“EXT-L” on the unit’s display blinks when [DVD] is pressed.) Press [EXTLINK] to cancel the recording standby.If the Child Lock function is activated, above operation does not work.Cancel the Child Lock function.−28, 77Startup is slow.  Startup takes time in the following situations:– A disc other than a DVD-RAM is inserted.– The clock is not set.– Immediately after a power failure or the AC mains lead is connected.– When the unit is connected with an HDMI cable. When “Power Save” is set to “Off”, startup becomes faster than when“Power Save” is “On”.−76General Issues Operation PageGeneral Issues GUIDE Plus+The GUIDE Plus+ system does notreceive any data. Check whether the clock is properly set. If signal quality is bad (ghost images or limited reception), the GUIDEPlus+ system may not be able to receive any data.14−“No Data” is displayed for some orall stations. Some stations are not supported by the GUIDE Plus+ system. Programme the Timer recording manually.−30The GUIDE Plus+ information isnot displayed properly. There was a programme change or GUIDE Plus+ information from abroadcast station was possibly not correctly transmitted.Check the current programme, e.g. on the Web site for the GUIDE Plus+system provider or station provider.−Troubleshooting GuidePage