Panasonic DMR-XW480 Operating Instructions Manual

Also see for DIGA DMR-XW380: Operating instructions Operating instructions

Convenient functionsVQT2J6282Changing the unit’s settings∫ Standby Settings¾ Power Save in Standby≥If the clock has not been set, “Power Save in Standby”is activated at all hours.≥This function cannot be enabled when the DLNAfunction is enabled in "Home Network ( DLNA )Settings" or "Server ( DLNA ) Settings". (> 81)¾ Automatic StandbySet the time to automatically turn the unit off.After the unit has finished operating, the unit will beturned off once the set time has passed.¾ Automatic Standby after OTRIf “On” is selected, this unit is turned to standby modewhen this unit is not operated for approximately5 minutes after completing One Touch Recording(> 26).¾ Automatic Standby after CopyIf “On” is selected, this unit is turned to standby modewhen this unit is not operated for approximately5 minutes after completing copy (> 45).∫ Remote ControlChange the remote control code on the main unit and theremote control if you place other Panasonic products closetogether.≥Use “DVD 1”, the factory set code, under normalcircumstances.1 Select the code, then press [OK].To change the code on the remote control2 While pressing [OK], press and hold the numberedbutton ([1] to [6]) for more than 5 seconds.3 Press and hold [OK] for more than 5 seconds.4 Press [OK].≥Operation is possible only with Panasonic remote controlswith “IR6” printed at the bottom when the remote controlcode of this unit is set to “DVD 4”, “DVD 5” or “DVD 6”.∫ ClockIf the time is not set correctly, use the settings listed inthe method below.≥AutomaticThis unit usually obtains time and date information fromdigital broadcasts.But, if the time is not set correctly, set it to “Off” andperform “Manual Setting”.≥Region SelectionSelect the region where you live to adjust the standardtime.≥The time contained in the broadcast signal is UTC(Universal time, coordinated).≥Daylight Saving TimeSelect time offset from the standard time for SummerTime.≥If there is a gap between displayed time and actualtime, set this function.≥Manual Setting1 Select “Off” of “Automatic”, then press [OK].2 Select the item you want to change.3 Change the setting.4 Press [OK] when you have finished the settings.∫ PIN EntryYou can set/change the PIN. (> 74)OthersOn It will go into the Power Save in Standbymode.On Timer “Power Save in Standby” is activatedwhen the set time comes.Off It is possible to start quickly from thestandby mode. (Quick Start mode)DVD IR6DVD IR6IR6ClockTime DateDaylight Saving TimeRegion SelectionAutomaticPlease set the clock.OK: access RETURN: leaveOKRETURN0 00 10NSW / ACT AutomaticOn1 1 2010