Panasonic DP-2310 Service Handbook

Also see for Workio DP-2310: User manual Service handbook Service manual Operating instructions Operating instructions

Contents

100DP-2310/3010APR 2003Ver. 1.00026 Non-Standard 1 = Off (Invalid)2 = On (Valid)Selects own mode (Panafax mode).027 Short Protocol B 1 = Off (Invalid)2 = On (Valid)Selects the short protocol mode.028 Short Protocol D 1 = Off (Invalid)2 = On (Valid)Selects the short protocol mode. When activated, itallows the machine to automatically store themodem speed for each Auto Dial Number.029 RemoteDiagnostics1 = Off (will not accept)2 = On (accepts)Selects whether the machine accepts RemoteDiagnostics from the service station.030 CED & 300 bps 1 = 75 ms2 = 1 secSelects the pause interval between the CED and the300 bps signal.(Used when Echo Suppression is disabled.)031 RTC = EOL x 12 1 = Off (EOLx6)2 = On (EOLx12)Selects the RTC signal, EOLx6 or EOLx12.032 V34 TX Start 2400-33600bps Selects the transmission modem start speed for V.34communication, 33600-2400 bps.033 V34 RX Start 2400-33600bps Selects the receiving modem start speed for V.34communication, 33600-2400 bps.034 V34 TX SR 2400-3429sr Selects the transmission symbol rate for V.34, 3429/3200/3000/2800/2400 sr.Press “V” or “/\ “ to select the symbol rate.035 V34 RX SR 2400-3429sr Selects receiving symbol rate for V.34, 3429/3200/3000/2800/2400 sr.Press “V” or “/\ “ to select the symbol rate.036 Not Used037 Protocol Display 1 = Off (not displayed)2 = On (displayed)Selects whether to display the modem speed duringcommunication.(Press the Job Status Key to display)038 Not Used039 Flash Time 5 = 50 ms~100 = 1000 msSelects the pause interval before activating the Flashkey.040 Flash Time(PSTN)5 = 50 ms~100 = 1000 msSelects the pause interval before activating the Flashkey.(For Germany, Austria and Czech)041 Pause Time 1 = 1 sec.~10 = 10 sec.Selects the pause interval from 1 sec. ~ 10 sec. fordialing through a switchboard or for internationalcalls.042 Not Used043 Redial Interval 0 = no waiting~15 = 15 minutesSelects the redial interval from 0 to 15 minutes in 1minute steps.044 Redial Count 0 = no redial~15 = 15 times0 ~ 9 (For Australia Only)Selects the redial count from 0 to 15 times in 1 stepintervals.Note:In order to comply with the requirements TBR21in the EC countries, do not select 15 times.045 Ring DetectCount1 = 1 ring~9 = 9 ringsSelects the ring detection count from 1 to 9 rings in 1ring step intervals.Function Parameter TableNo. Parameter Selections Function