Panasonic DP-3010 Service Handbook

Also see for DP-2330: Specification Operating instructions Operating instructions Operating instructions Service manual

Contents

51DP-2330/3030DEC 2004Ver. 2.0DP-2310/30102.8. Adjusting the Printer Registration, LSU Image Side to SideWhen installing the Paper Tray option, the following LSU Image Side to Side adjustment must beperformed.The Printer registration is adjusted at the factory.If copy image is abnormal, specially in the Rotation Copy mode, adjust it by the following procedure.2.8.1. Printer Registration1. Insert Ledger or A3 size paper into the 1st tray and change the tray setting to the appropriate papersize. Empty or pull out all the remaining trays (including the bypass tray) to disable them.2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that orderto enter the Service Mode.3. Perform the Service Mode F1-03 (Print Test Pattern 1).4. Check the gap of the print pattern from the paper edge, refer to the Figure below.5. Perform the Service Mode F6-04 (Printer Registration) to adjust the gap to be 5 mm.6. If the gap is less than 5 mm, input a (-) value. If more than 5 mm, input a (+) value.7. Press "STOP" first and then press "FUNCTION" + "CLEAR" keys simultaneously to return tostandby.2.8.2. LSU Image Side to Side Adjustment for the Tray1. Insert paper into the 1st tray and change the tray setting to the appropriate paper size. Empty or pullout all the remaining trays (including the bypass tray) to disable them.2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that orderto enter the Service Mode.3. Perform the Service Mode F1-03 (Print Test Pattern 1).4. Check the gap of the print pattern from the paper edge, refer to the Figure above.5. Perform the Service Mode F6-10 to F6-14, to adjust the gap to be 5 mm.6. If the gap is less than 5 mm, input a (+) value. If more than 5 mm, input a (-) value.7. Proceed the above steps for other Tray.8. Press "STOP" first and then press "FUNCTION" + "CLEAR" keys simultaneously to return tostandby.2.8.3. LSU Image Side to Side Adjustment for the ADU1. Insert paper into the 1st tray and change the tray setting to the appropriate paper size. Empty or pullout all the remaining trays (including the bypass tray) to disable them.2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that orderto enter the Service Mode.3. Perform the Service Mode F1-06 (Print Test Pattern 4).4. Check the gap of the print pattern from the paper edge, refer to the Figure above.

Two lines are printed on the top (Lead edge).For Ledger or A3, place as Portrait.For Letter or A4, place as Landscape.5 mmTop (Lead edge)Two lines are printed5 mm 5 mmTwo lines are printed