97DP-2330/3030MAR 2005Ver. 2.1DP-2310/30103.7. Updating the FirmwareThe Quickest and Most Easiest Method of Updating the Firmware is to use the Network FirmwareTool (FUP) using Ethernet LAN Port and a Crossover Cable.The Network FUP Tool version must be 3.XX or higher, and it can be found on the Panasonic DocumentManagement System CD-ROM included with the main unit or on the CD-ROM included with the PCL orPS/PCL options.Refer to the Firmware Update Operation Instructions, Service Notes (8.1. or 8.2) for additionaldetails.3.7.1. Firmware ConfigurationA. Hardware ConfigurationThis machine is controlled by three (3) CPUs which are located on the System Control (SC) PCBoard, the Scanner Printer Control (SPC) PC Board and the Panel Control (PNL) PC Board.B. SC PC Board FirmwareThe 4 MB Program Memory (F-ROM) is integrated on the SC PCB. Two (2) Optional Expansion 8 MBProgram Memory (FRM8 PCB) can be installed into SLOT 1 and SLOT 2.The Firmware to be written into the 4 MB onboard, the 8 MB of SLOT 1 / SLOT 2 depends upon theconfiguration of the Standard, PCL or PS Options.(1) StandardThe Standard Program (1) is only written into the 4 MB onboard, which is assigned as ROMCode (A).SC PC Board StandardConfigurationWith PCL OptionConfigurationWith PS OptionConfigurationOn Board (A)4 MB(B)4 MB(D)4 MBPC (1) (2) (5)CPU 4 MB Program Program ProgramEthernet PortF-ROMPCUSB Port Slot 1 (C) 8MB (E) 8MB(3) (6)Program Program8 MB2 MB (a) 4 MB (a)FRM8 PCB(4) (7)Flash MemoryCardFont4 MB or 8 MB4 MB (b) 4 MB (b)Slot 28 MBFRM8 PCBPNL PC BoardPanel Control Program (Display & Key In)CPU 4 MBBitmap DataF-ROMFont DataSPC PC BoardCPU 512 KBScanner Control ProgramF-ROMPrinter Control ProgramFont
