Panasonic DVD-LS855PK Operating Instructions Manual

Also see for DVD-LS83: Operating instructions Operating instructions Operating instructions

Contents

14RQT9201Enjoying in various situationsEnjoying in various situationsEnjoying in a carYou can enjoy video in the back seat attaching the unit to the back of thefront seat.≥ Please insert the disc before attaching the unit to the headrestmounting bracket.1 Attach the headrest mounting bracket to the frontseat.2 Adjust the monitor.3 Attach the unit to the bracket.While holding the unit with both hands, line up the unit just below theprotruding sections on the bracket. Press the unit down about 4 to 5 mmso that the protrusions on the bracket fit into the holes on the bottom ofthe unit.≥ Please check the following points before use.– The bracket is securely fastened to the unit.– The unit is not loose and cannot be lifted upwards.≥ Do not leave the unit on a surface that may become hot such as a dashboard. The unit is not heat-resistant so may malfunction.≥ DRIVER MUST NOT OPERATE OR VIEW THIS UNIT WHILE OPERATING THE VEHICLE.Doing so will distract the driver and could cause a collision resulting in serious injury or property damage.Enjoying video in the back seat with the Headrest Mounting Bracket≥ Do not attach or detach the unit or the bracket while the car ismoving.≥ Do not attach the unit in the following locations:– anywhere other than the back of the front seat– where it can be viewed or operated by the driver– where it interferes with the driver’s operation of the vehicle– where it interferes with the operation of an airbag≥ Ensure that the bracket belt is securely fastened and check thelock on the unit. Refer to installation instructions.In the event of an accident, sudden acceleration or braking, the unitcould become loose and cause injury or property damage.≥ Only use the Panasonic bracket supplied to attach the unit tothe car seat.Rotate the monitor backwards so the screen is facing out.(➜ 4, Adjusting the LCD angle)Headrest MountingBracket (included)2 Close the buckle and adjust the belt until it fits tightlyaround the headrest.1 Adjust the headrest so there is an open space of about 3 cm.Attach to the seat sothat the label side ofthe bracket can beseen from the rear ofthe seat.Side viewIf this space is larger than 3 cm,the unit could become loose andcause injury in the event of anaccident etc.DO DO NOT≥ Depending on the type of headrest, you may not be able to attach thebracket.1 Press the release buttons (left and right) in towards the center ofthe bracket.2 Lift the unit up to release it.≥ Do not press the release buttons any time other than when detachingthe unit from the bracket.30˚Line up the protrudingsections here.Use the monitor in the open positionas shown in the illustration below toprevent abnormal audio or damageresulting from vibrations in the car.The angle of the monitor can beadjusted up to about 30o.Diagram of theattached bracket andunit≥ The angle ofthe monitormay shiftwhile drivingdue tovibration, etc.When correctlyattached, you willhear a lockingsound.click!23 cm or less In the event of an accident etc., the unitcould become loose and cause injury.DO DO NOTReleasing the unit from the bracketRelease button