Panasonic DVD Palmcoder VDR-D250 Operating Instructions Manual

Also see for DVD Palmcoder VDR-D250: Operating instructions Operating instructions

Panasonic DVD Palmcoder VDR-D250 Operating Instructions Manual Manual pdf 152 page image

TroubleshootingTroubleshootingUnit operationsPQ)OThis unit cannot beturned on.This unit is turned offautomatically.This unit does not stayon long enough.Battery runs down• Is the battery fully charged?Charge the battery using the AC adaptor. (4 28)• The battery protection circuit may have operated. Attachthe battery to the AC adaptor for 5 to 10 seconds. If the unitstill cannot be used, the battery is faulty.• Is the LCD monitor opened or the viewfinder extended?• If you do not use the unit for approximately 5 minutes, thepower is automatically turned off to conserve the batterycharge. To resume recording, turn the power back on.The power will not turn off automatically when the powersave function (4 144) is set to [OFF].• Is the battery low?If the remaining battery power indication is flashing or themessage "LOW BATTERY." is displayed, the battery has rundown. Charge the battery. (4 28)• Is the battery fully charged?Charge it with the AC adaptor. (4 28)• Are you using the battery in an extremely cold place?The battery is affected by ambient temperature. In coldplaces, the operating time of the battery becomes shorter.• Has the battery worn out?The battery has a limited life. If the operating time is still tooshort even after the battery is fully charged, the battery hasworn out and can no longer be used.• The unit cannot be operated unless you open the LCDThis unit cannot beoperated thoughThis unit does notoperate normally.The screen has changedsuddenly.monitor or extend the viewfinder.• Press the RESET button. (4 155) If normal conditions arenot restored yet, remove the battery or AC adaptor, waitabout 1 minute and then reconnect the battery or ACadaptor. Then about 1 minute later, turn on the poweragain. (Conducting the above operation when the accesslamp is on may destroy the data on the disc or card.)• Has the demonstration started?If you set [DEMO MODE] to [ON] without inserting a disc or acard in disc recording mode or card recording mode, the unitis automatically set to the demonstration mode forintroducing its functions. Normally this should be set to[OFF]. Press the MENU button, then select [SETUP][DEMO MODE] _ [OFF] and press the joystick.152LSQT1011