Panasonic Diga DMR-EH57 Operating Instructions Manual

Also see for Diga DMR-EH57: Operating instructions Service manual

Contents

26RQT8906Timer recordingSee also “Important notes for recording” (➡ 8).Depending on the type of disc used for recording or the type ofbroadcast, there may be restrictions on the title you are trying torecord.[HDD] [RAM] [-R] [-RW‹V›] [+R] [+RW]≥You can enter up to 32 programmes up to a month in advance.(Each daily or weekly programme is counted as one programme.)[RAM] [-RW‹V›] [+R] [+R]DL] [+RW]≥To use a new disc, formatting is necessary.Preparation≥Turn on the television and select the appropriate video input to suitthe connections to this unit.≥If recording to DVD, insert a disc that you can use for recording(➡ 22).≥Make sure that the clock settings are correct (➡ 67).[For]Australia]and]N.Z.][For]Australia]and]N.Z.]Entering G- CODE numbers is an easy way of timer recording. You canfind these numbers in TV listings in newspapers and magazines.1 Press [G-Code].2 Press the numbered buttons to enterthe G- CODE number.Press [2] to move back to correct a digit.3 Press [OK].≥Confirm the programme (start and end time) by using a TVmagazine, etc. and make corrections if necessary using[3, 4, 2, 1] (➡ 27, step 3).≥When “-- ---” appears in the “Name” column, you cannot settimer recording. Press [3, 4] to select desired programmeposition. After you have entered the information of a TVstation, it is kept in the unit’s memory.4 Press [OK].The timer programme is stored and the timer icon isdisplayed.“F” lights on the unit’s display to indicate timer recordingstandby has been activated.Repeat steps 1–4 to programme other recordings.Press [Í DVD] to turn the unit off.∫ To cancel recording when recording has alreadybegun (➡ 28)∫ To release the unit from recording standby(➡ 28)∫ Notes on timer recording (➡ 28)G- CODE is a registered trademark ofGemstar Development Corporation. TheG- CODE system is manufactured underlicense from Gemstar DevelopmentCorporation.STATUSF RecREC MODERECMANUAL SKIPAUDIO DISPLAY CREATECHAPTERFUNCTIONMENUDIRECTNAVIGATORPROG/CHECKRETURNPLAY/x1.3PAUSESTOPSLOW/SEARCHSKIPINPUT SELECTCH0987654321CHAVÍTVDRIVESELECTÍDVDVOLDELETE G-CodeEXITTIME SLIPOKOPTION-/--PROG/CHECKG-Code3,4,2,1OKDRIVESELECTREC MODEÍ DVDNumberedbuttonse.g., [Australia]and]N.Z.] Using G-CODE system to make timerrecordingsG-CodeRecord1:58 SPDVD30:24 SPHDDRemain12:53:00 15. 7. TUEInput G-Code Number 0-9, and press OK.G-CodeRecord1:58 SPDVD30:24 SPHDDRemain12:53:00 15. 7. TUEInput G-Code Number 0-9, and press OK.TimerRecording 1:58 SPDVD30:24 SPHDDRemain12:54:00 15. 7. TUEModeStopStartName Date HDDDVD20:0019:0015. 7. TUE SPHDD1 ARDProgramme NameNo. NameARD01Timer icon12:56:00 15. 7. TUEModeStop HDDDVDHDDDrivespaceSP OK20:00ProgrammeCheck to make sure “OK”is displayed (➡ 29).