Convenient functionsVQT4L3182Software (Firmware) UpdateSoftware of this unit can be updated automaticallyby the following methods at the specified time.(Default setting is 3 a.m. > 80, Software Updatein Standby)- From broadcasts- From Internet§• To update the software (Firmware) immediately,use the following function:- Software Update Now ( Broadcast ):Software of this unit will be updated frombroadcasts if update information is detected.- Software Update Now ( Internet )§:Software of this unit will be updated fromInternet if update information is detected.§ Network connection and setting are required.(> 17, 20)If a software (firmware) update is available, anotification is displayed.• It is displayed on the channel information (> 24)when the Software (Firmware) can be updatedimmediately.To execute, press the red button while thechannel information is displayed, and follow theinstructions on the screen.Update of the software (firmware) will start whenthe unit is turned to standby mode.e.g.,• When “FINISH” is displayed, update of thesoftware (firmware) has completed.• It may take up to a few hours until the update is completeddepending on the network or broadcast environment.• The timer recording always takes preference over thesoftware (Firmware) download; if the timer recording isscheduled to start, the downloading will be performed at thenext opportunity.• You can also download the latest software (firmware) fromthe following website.http://panasonic.jp/support/global/cs/You cannot operate the unit until the updateis complete. Don’t remove the AC mains leadduring the update. Removing the AC mainslead while the update is in progress maydamage the unit.The unit’s display during the updateNew software version has been found.The software will be updated automaticallyafter this unit is switched to standby.Do not disconnect the AC mains lead.10:30 AM1NowDolby DRating: GChange categoryAll Digital ChannelsNEWS9:00 AM - 11:00 AMSoftware updatee.g.,