Panasonic EB-GD35 Service Manual

Also see for EB-GD35: Operating instructions Operating instructions

http://cxema.ruEB-GD35 EB-GD35C214 DISASSEMBLY / REASSEMBLY INSTRUCTIONS4.1. GeneralThis section provides disassembly and reassembly procedures for the main components of the telephone.These assemblies MUST be performed by qualified service personnel at an authorised service centre.The following Warnings and Cautions MUST be observed during all disassembly / reassembly operations:4.1.1 ESD Handling PrecautionsA working area where ESDs may be handled safely without undue risk of damage from electrostatic discharge, must be available.The area must be equipped as follows:Working SurfacesAll working surfaces must have a dissipative bench mat, safe for use with live equipment, connected via 1M2 resistor (usuallybuilt into the lead) to a common ground point.Wrist StrapA quick release skin contact device with a flexible cord, which has an integral safety resistor of between 5k2 and 1M2, shall beused.ContainersAll containers and storage must be of the conductive type.4.2. Disassembly4.2.1 Case Removal1.Remove the battery cover by pushing it towards the base of the phone and then lifting it away fromFigure 4.1: Battery Cover RemovalWARNINGThe equipment described in this manual contains polarised capacitors utilising liquid electrolyte. These devices are entirely safe providedthat neither a short-circuit nor a reverse polarity connection is made across the capacitor terminals. FAILURE TO OBSERVE THISWARNING COULD RESULT IN DAMAGE TO THE EQUIPMENT OR, AT WORST, POSSIBLE INJURY TO PERSONNEL RESULTINGFROM ELECTRIC SHOCK OR THE AFFECTED CAPACITOR EXPLODING. EXTREME CARE MUST BE EXERCISED AT ALL TIMESWHEN HANDLING THESE DEVICES.CautionThe equipment described in this manual contains electrostatic devices (ESDs). Damage can occur to these devices if the appropriatehandling procedure is not adhered to.10382-1