Panasonic ET-DFD95 Installation Instructions Manual

3Assembled bracket with projectorsBracket componentsThis bracket is exclusively for the installation of dual DLPTM projectors. The bracket is made up of the followingcomponents. Before assembling the bracket, confirm that all components have been provided.Structural componentsBase frame 1 Left frame, right frame 1 each Gas springs 2Upper frame 1 Left guard frame, right guard frame 1 eachUse the following to mount the lowerprojector in the base frame.Flat washers (M10) 4Spring washers (M10) 4Hex bolts (M10) 4For mounting the lower projector. Attaches to the base frame, then the upper frame isattached.Attaches to the upper frameand left and right frames tosupport the weight of theupper projector.For mounting the upper projector. Then the frame and upper projector areattached to the left and right frames.After the upper and lower projectors are mounted,attaches to the left and right frames.Use the following to attach the left and right frames tothe base frame.Built-in allen hex socket bolts (M6x20) 6Allen hex socket bolts (M8x50) 6Use the following to installthe gas springs.Plate bolts (M5x10) 8Use the following to attach the left and right guardframes to the left and right frames.Flat washers (M6) 14Spring washers (M6) 14Allen hex socket bolts (M6x50) 14Use the following to attachthe upperr frame to theupper projector.Use the following to attach the upperframe to the left and right frames.Special-purpose axes 2Washers 2Hex nuts (M12) 2Spring washers (M12) 2Flat washers (M12) 2Allen hex socket bolts (M10) 2Spring washers (M10) 2Flat washers (M10) 2Adjustment bolts (M10) 4Washers (A) 4Washers (B) 3Washers (C) 1Mounting nut (M10) 4Hex nuts (M10) 4Snap pins 4Upper projectorLower projector