Installing the Interface Board6 - ENGLISHr Interface Board for DVI‑D 2 input (Model No.: ET‑MDNDV10)13 321 ‑D IN 1> terminal (when installedin 1> of the display device),‑D IN 3> terminal (when installedin 2> of the display device)This is a terminal to input the DVI-Dsignal.2 ‑D IN 2> terminal (when installedin 1> of the display device),‑D IN 4> terminal (when installedin 2> of the display device)This is a terminal to input the DVI-Dsignal.3 HandleInstalling the Interface BoardIt is recommended to ask a qualified technician to install or remove theInterface Board to a projector. A malfunction may occur due to staticelectricity. Consult your dealer.Ask a qualified technician to install or remove the Interface Board to/from aflat panel display. There is a danger of electric shock or a malfunction mayoccur due to static electricity. Consult your dealer.Before installing or removing the Interface Boardf Always turn off the power of the display device (projector or flat paneldisplay) before installing or removing the Interface Board.g Make sure to follow the procedure described in the OperatingInstructions of your display device when turning off the power.f Do not touch the connector section of the Interface Board directly with yourhands.g The component may be damaged by the static electricity.f Remove the static charge from your body by touching the surroundingmetal, etc., in advance to prevent the static electricity damage.f Take care not to get injured when installing or removing the InterfaceBoard.g Hands may be injured by the opening of the blank slot of the displaydevice or the edge of the bracket of the Interface Board.f When installing the Interface Board to the slot, insert it into the connectorstraight and slowly.g It may not operate or cause malfunction if it is not correctly installed.
