Panasonic EY6812 Operating Instructions Manual

Also see for EY6812 - HAMMER COR.DRILL&DR: Operating manual Service manual Service manual

13) Do not force tool. Use the correcttool for your application.The correct toot wilt do the job betterand safer at the rate for which it isdesigned.14) Do not use toot if switch does notturn it on or off.A tool that cannot be controlled withthe switch is dangerous and must berepaired.15) Disconnect battery pack from toolor place the switch in the locked oroff position before making anyadjustments, changing acces¬sories, or storing the tool.Such preventive safety measuresreduce the risk of starting the tool acci¬dentally.16) Store idle tools out of reach ofchlldrsn and other untrained per¬sons.Tools are dangerous in the hands ofuntrained users.17) When battery peck is not In use,keep it away from other metalobjects like: paper clips, coins,keys, nails, screws, or other emailmetal objects that can make a con¬nection from one terminal toanother.Shorting the battery terminals togeth¬er may cause sparks, bums or a fire.16) Maintain tools with care. Keep cut¬ting tools sharp and clean.Property maintained tools with sharpcutting edge are less likely to bindand are easier to control.19) Check for misalignment or bindingof moving parts, breakage of parte,and any other condition that mayaffect the tool's operations. If dam¬aged, have the tool serviced beforeusing.Many accidents are caused by poorlymaintained tools.20) Uas only accessories that are rec¬ommended by the manufacturerfor your model.Accessories that may be suitable forone toot may create a risk of injurywhen used on another too).Service21) Tool service mutt be performedonly by qualified repair personnel.Service or maintenance performed byv unqualified personnel may result in arisk of injury.22) When servicing a tool, use onlyidentical replacement parts. Followinstructions In the Maintenancesection of this manual.Use of unauthorized parts or failure tofollow Maintenance Instructions maycreate a risk of shock or injury.SPECIFIC SAFE¬TY RULES1) Hold tool by Insulated grippingsurfaces when performing anoperation where the cutting toolmay contact hidden wiring.Contact with a “live" wire will makeexposed metal parts of the tool live"and shock the operator.2) Wear ear protectors when usingthe tool for extended periods.Prolonged exposure to high intensitynoise can cause hearing loss.3) Be aware that this tool Is always Inan operating condition, it does nothave to be plugged into an electricaloutlet.4) Do not operate the reverting leverwhen the main switch is on.The battery will discharge rapidly anddamage to the unit may occur.5) If ths bit becomes Jammed, imme¬diately turn the main switch off toprsvsnt an overload which candamage the battery pack or motor.Use reverse motion to loosenJammed bits.6) When storing or carrying the tool,set the reversing lever to the cen¬ter (switch lock) position.7) Do not strain ths tool by holdingthe speed control trigger halfway(spaed control mode) so that thsmotor stops.