Panasonic EY7440LN2L Operating Instructions Manual

Also see for EY7440 - DRILL DRIVER 14.4V- MULTI-LANG: Operating instructions Operating instructions

Contents

- 9 -• When the belt hook is not used, besure to return it to the storing posi-tion. The belt hook may catch onsomething.This may result in an accident orinjury.• When the unit is hooked onto thewaist belt by the belt hook, do notattach driver bits to the unit. A sharpedge object, such as a drill bit, maycause injury or an accident.To Set the Belt Hook AnglePosition1. Slide the belt hook lock lever 1 andhold it to unlock the belt hook.2 13. Pull the belt hookfrom storing position2 and set it.3. Release the belt hooklock lever to lock theangle of belt hook.4. Make sure the belt hook is firmlylocked. Also make sure the belt hookis firmly locked into position 3.• The belt hook can-not be locked in thisposition. Firmly lockit into position beforeuse.To return the belt hook to the storingposition, follow step 1. and . above,then lower the belt hook.To secure the lock, follow 3 and 4above.To Change the Belt HookLocation SideThe belt hook can be attached toeither side of the unit.1. Set the belt hook at storing posi-tion.. Loosen the screw turning it coun-ter-clockwise, using a flat metal ora flat blade screw driver.3. Take out the belt hook and insertinto the other side of the slot on themain unit.4. Fasten the screw firmly, turning itclockwise.The belt hook can be taken out fromthe main unit only when it is at storingposition.Control Panel(1) ()(3)(1) LED lightPressing toggles theLED light on and off.The light illuminates withvery low current, and itdoes not adversely affectthe performance of thedriver during use or its bat-tery capacity.CAUTION:• The built-in LED light is designed toilluminate the small work area tem-porarily.• Do not use it as a substitute for aregular flashlight, since it does nothave enough brightness .This product has the built-in LED light.This product is classified into “Class 1LED Product ” to EN 6085-1Class 1 LED ProductCaution : DO NOT STARE INTO BEAM.(2) Overheat warning lampOff(normaloperation)Flashing: OverheatIndicates operation hasbeen halted due to batteryoverheating.The overheating protection featurehalts driver operation to protect thebattery pack in the event of over-heating. The overheat warning lamp