KEY POINTS• For using the Z-phase signal, control signal or comparison match flag asreset signals, turn on the reset enable request signal using user programs.5.3.2 Preset InputThe following three preset methods are available. Type of reset signalsPresetelement Setting methodPreset conditionONOFFONOFFONOFFONOFFOutput YrelayActivates the preset request signal by a userprogram. Input ZsignalAllocates the Z-phase input signal to either presetoperation using the configuration menu. Control 0signalAllocates the control 0 signal to either resetoperation using the configuration menu.Positive logic enable operation and presetoperation at rising edgeNegative logic enable operation and presetoperation at trailing edge I/O AllocationSignal name Effectivecondition CH0 CH1 CH2 CH3Preset request ON edge Y103 Y113 Y123 Y133Input Z signal monitor - X10A X12A X14A X16AControl 0 signal monitor - X10B X12B X14B X16B(Note 1): The above I/O numbers are those for the slot number 1 and the starting word number 10. The I/O numbersactually used vary according to the slot number where the unit is installed and the starting word number. Setting of preset valuesUnitmemoryNo.（Hex）Name Default Setting range and description UnitUM 00062UM 00063Presetvalue 0Set preset values.Setting range:-2,147,483,648 （8000 0000H） to 2,147,483,647 （7FFF FFFFH）Signed 32-bitPulseUM 00132UM 00133UM 00202UM 00203UM 002D2UM 002D3Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
