Panasonic G600 Service Manual

Also see for EB-BL600: Service manual Service manual

5 DISASSEMBLY/REASSEMBLY INSTRUCTIONS5.1 GeneralThis section provides disassembly and reassembly procedures for the main components of the G600 system.These procedures MUST be performed by qualified service personnel, at an authorized service centre.The following warnings and precautions MUST be observed during ALL disassembly/reassembly operations:WARNINGThe equipment described in this manual contains polarised capacitors utilising liquid electrolyte. These devicesare entirely safe provided that neither a short-circuit nor a reverse polarity connection is made across thecapacitor terminals. FAILURE TO OBSERVE THIS WARNING COULD RESULT IN DAMAGE TO THEEQUIPMENT OR, AT WORST, POSSIBLE INJURY TO PERSONNEL RESULTING FROM ELECTRIC SHOCKOR THE AFFECTED CAPACITOR EXPLODING. EXTREME CARE MUST BE EXERCISED AT ALL TIMESWHEN HANDLING THESE DEVICES.CautionThe equipment described in this manual contains electrostatic sensitive devices (ESDs). Damage can occur tothese devices if the appropriate handling procedure is not adhered to.ESD Handling precautions:A working area where ESDs may be safely handled without undue risk of damage from electrostatic discharge,must be available. The area must be equipped as follows:Working Surfaces - All working surfaces must have a dissipative bench mat, SAFE for use with live equipment,connected via a 1M2 resistor (usually built into the lead) to a common ground point.Wrist Strap - A quick release skin contact device with a flexible cord, which has a built in safety resistor of between5k2 and 1M2 shall be used. The flexible cord must be attached to a dissipative earth point.Containers - All containers and storage must be of the conductive type.MCUK980101C8 Section 5 Issue 1Service Manual 5 - 1 Revision 0DISASSEMBLY/REASSEMBLY INSTRUCTIONS