Panasonic G600 Service Manual

Also see for EB-BL600: Service manual Service manual

7.4 Channel Box Test CommandsThe following table outlines the commands available using the channel-box software.After the handheld unit has been switched on (section 7.3), use the up/down scroll keys on the personal computerkeyboard to select the channel-box command. Use the left/right scroll keys to display the required indication andpress the ENTER key to select the displayed function.CHANNEL BOX COMMAND INDICATION FUNCTIONTEST MODETerminates test mode.Restarts test mode.INITIALIZE When RETURN is pressed this willreset the default channel settings.CHANGE CH Sets up predefined channelsettings.POWER LEVEL Allows a specified power level to beset at the UUT.TX DATASets TX Modulation to:Normal burst DATA all 0sNormal burst DATA all 1sNormal burst DATA all randomAccess burst DATA randomRSSI (DBM) Provides an RSSI reading on theUser specified channel.SET AGC 1SET AGC 2SET AGC 3Allows changes to AGC levels onLOW, MIDDLE, HIGH channels.SP LOOP BACKProvides an audio path for use withthe GSM test station.Sets audio loop-back from TXaudio to RX audio withoutprocessing by the CODECPATH CONTSets audio paths:MIC off speaker offMIC external speaker internalMIC external speaker externalMIC internal speaker internalMIC internal speaker externalVOL. BUZZ Sets buzzer volume betweenvalues0 to 3 (Min to Max)VOL. SIDE Sets 4 side tone volume levelsbetween0dB and -18dBVOL. MIC Sets 8 MIC volume levels between26dB and 40dBTAM CONTPLAY ONPLAY OFFREC ONREC OFFSwitches on Voice Memo PlaybackSwitches off Voice Memo PlaybackRecord Voice Memo onRecord Voice Memo offVOL. SP1 Sets speaker pre-amp volumelevelsVOL. SP2 Sets speaker volume levelsGET KEY CODE Displays the value of a key pressedon the keypadMCUK980101C8 Section 7 Issue 1Service Manual 7 - 7 Revision 0TEST AND MEASUREMENT