Panasonic GP-US522HB Operating Instructions Manual

Also see for GP-US522HB: Manual Manual Manual Brochure Quick reference guide

Panasonic GP-US522HB Operating Instructions Manual Manual pdf 10 page image

241SCANNING MODESelect Input+15 V InputGround (GND)Chip Select 1 InputVL InputB Signal OutputSerial Data InputSerial Clock InputCCD Select OutputG Signal OutputR Signal OutputVD InputCPOB OutputHD Input+9 V Input/Not used+5 V InputSerial Data OutputChip Select 2 InputNot usedNot usedNot usedTGCLK InputNot usedGround (GND)Chip Select 2 OutputSerial Data Input+9 V Output/Not usedVL OutputCPOB InputSCANNING MODESelect Output+5 V OutputB Signal InputSerial Clock OutputVD OutputChip Select 1 Output+25 V Output/HCLR InputR Signal InputSerial Data OutputHD OutputG Signal Input+15 V OutputCCD Select InputTGCLK Output1071Camera Head Side Camera Control Unit Side17. Camera Cable Connector (CAMERA)This 20-pin connector is used for connection with thecamera head via the optional camera cable GP-CA522/4.Fasten the camera cable to this connector firmly.If not, noise may be appeared.19. Video Output Connector (VIDEO)A 1.0 V[P-P]/75 Ω composite video signal is provided atthis connector.20. Gen-lock Signal Input Connector (VBS/HD)The color video signal of the camera is automaticallysynchronized with the gen-lock signal (CompositeSignal, Black Burst Signal or Video Sync) when eithersignal is supplied to this connector.The gen-lock signal is used for system reference.Caution:If the gen-lock signal is jittery (as in the case of aVCR (VTR) playback picture), the camera cannot besynchronized properly.(External HD and VD Mode)The horizontal and vertical pulse of the color videosignal is synchronized with the external HD fed tothis connector and external VD fed to the VD inputconnector when using in the External HD and VDMode.[Rear Panel]For CameraVIDEOS-VIDEO VBS/HD VD ONOFFDC 12V INOFF1 RGB2 INTER.3 NOT USE4 RS-232CYPbPrPROGRE.NOT USEFRONT SWON75ΩRGB/YPbPr RS-232CG/ L ON1 2 3 4!9!8@3 @4 @6@0 @1 @2 @5Connecting or disconnecting the camera cableto/from the camera control unit or camera headmust be done after turning off the Power of thecamera control unit.Caution12 56 101511192016For CCU2122152024 232 11617101112567181913148934S-VIDEO (Mini-DIN,4-pin)Pin No. Description1 Y Ground (GND)2 C Ground (GND)3 Y Signal Output (For NTSC 0.714 V[P-P],for PAL 0.7 V[P-P] (Y level)/75 Ω)4 C Signal Output (For NTSC 0.286 V[P-P],for PAL 0.3 V[P-P] (Burst Level)/75 Ω)18. S-Video Output Connector (S-VIDEO)The luminance (Y) and chrominance (C) signals forVCR (VTR) or monitor are provided at this connector.4 32 1234567891011121314151617181920234 +25 V Input/HCLR Output56891011121314151617181920212223