9-4Setting for EHV-CPU128/EHV-CPU64/EHV-CPU32/EHV-CPU16It should be specified with a programming tool.Specify the setting for the serial port as below with a programming tool.Item SettingType Special portPort type *1For RS232C connection: RS232CFor RS422 connection: RS422/485For RS485 connection: RS422/485Baud rate 19200bpsCommunication procedure Procedure 1 of transmission control (No unit No.) 1:1 communicationUnit No. No unit No.With modem connection Not check*1 It varies according to the communication method.*2 For the details of the method of communication setting, refer to the "EH-150EHV series LadderProgramming Software Control Editor Instruction Manual".Setting for EH-SIOPort 1 or Port 2The setting for the dip switches and the ladder program to perform the default setting is required.Specify as below with the dip switches for each port.Item SettingBaud Rate 19200bpsData Length 1Parity Bit EvenStop Bits 7Specify the setting for the communication port of EH-SIO with a ladder program as below.Item SettingDefault setting of communication mode Hi-Protocol modeCommunication procedure Procedure 1 of transmission control (No unit No.)Unit No. No* For the details of the method of communication setting, refer to the "EH-150 Application Manual".
