Panasonic HC-X1 Operating Instructions Manual

Also see for HC-X1: Operating instructions

4DVQX1102Note regarding the Power Managementfunction specified under COMMISSIONREGULATION (EC) No 1275/2008implementing Directive 2009/125/EC of theEuropean Parliament and of the Council.This device is designed and manufactured foruse at a broadcasting station and/or in a similarenvironment.This device is not equipped with a PowerManagement function or the PowerManagement function is set to OFF as it willprevent the device from fulfilling its intendedpurpose for the reasons below.1. If the device is a Studio Camera, a WeatherCamera, a Mixer or other processor:A Power Management function maycause the device to suddenly stopduring recording or while On Air.2. If the device is a Studio Monitor:A Power Management function maycause video for the confirmation ofwhether a signal is normal, or whetherthe signal has been lost, to be un-viewable.3. If the device is a Camera Recorder:A professional camera recorder must beable to start quickly at any time, but aPower Management function will causean increase in the time taken to resumefrom Stand-by mode.∫ Cautions for useKeep this unit as far away as possible fromelectromagnetic equipment (such asmicrowave ovens, TVs, video games etc.).≥ If you use this unit on top of or near a TV, thepictures and/or sound on this unit may bedisrupted by electromagnetic wave radiation.≥ Do not use this unit near cell phones becausedoing so may result in noise adverselyaffecting the pictures and/or sound.≥ Recorded data may be damaged, or picturesmay be distorted, by strong magnetic fieldscreated by speakers or large motors.≥ Electromagnetic wave radiation generated bymicroprocessors may adversely affect thisunit, disturbing the pictures and/or sound.≥ If this unit is adversely affected byelectromagnetic equipment and stopsfunctioning properly, turn this unit off andremove the battery or disconnect AC adaptor.Then reinsert the battery or reconnect ACadaptor and turn this unit on.Do not use this unit near radio transmittersor high-voltage lines.≥ If you record near radio transmitters orhigh-voltage lines, the recorded pictures and/or sound may be adversely affected.About connecting to a PC≥ A USB 3.0 cable is not supplied with this unit.Use a commercially-available double-shielded USB 3.0 cable with a ferrite core.If possible, we recommend using a cable witha length of 1.5 m or less.About using a headphone≥ Excessive sound pressure from earphonesand headphones can cause hearing loss.≥ Listening at full volume for long periods maydamage the user’s ears.Make sure to use the supplied cords andcables. If you use optional accessories, use thecords and the cables supplied with them.Do not extend the cords and the cables.Do not spray insecticides or volatilechemicals onto the unit.≥ If the unit is sprayed with such chemicals, itsbody may be marred and the surface finishmay peel off.≥ Do not leave rubber or plastic products incontact with the unit for a long time.When you use the unit in a sandy or dustyplace such as a beach, do not let sand orfine dust get into the body and terminals ofthe unit.Also, keep the unit away from sea water.≥ Sand or dust may damage the unit. (Careshould be taken when inserting and removinga card.)About this unitThe unit and the SD card become warmduring use. This is not a malfunction.