13VQT4C76∫ Inserting the batteryOpen the LCD monitor and install the batteryby inserting it in the direction shown in thefigure.≥ Insert the battery until it clicks and locks.∫ Charging the batteryA DC input terminal1 Connect the AC cable to the ACadaptor, then the AC outlet.2 Connect the AC adaptor to the DC inputterminal.≥ The status indicator will flash red at aninterval of 2 seconds (approximately 1second on, 1 second off), indicating thatcharging has begun. It will turn off whenthe charging is completed.∫ Inserting/removing an SD card≥ Check that the access lamp has gone off.1) Open the SD card cover and insert/remove the SD card into/from the cardslot.≥ Face the label side B in the directionshown in the illustration and press itstraight in as far as it will go.≥ Press the center of the SD card and thenpull it straight out.2) Press the C part of the SD card coverand close the SD card cover.≥ Securely close it until it clicks.Quick GuideAccess lamp [ACCESS] A≥ When this unit is accessing the SDcard or built-in memory, the accesslamp lights up.
