31LSQT1093SetupSetupCharging the batteryWhen this unit is purchased, the battery is notcharged. Charge the battery before using thisunit.≥If the DC cable is connected to the ACadaptor, then the battery will not charge.Remove the DC cable from the AC adaptor.≥The Panasonic battery that can be usedwith this unit is VW-VBG260. OtherPanasonic batteries will not work. (l 32)1 Connect the AC cable to the ACadaptor and the AC outlet.≥Remove the DC cable beforehand.2 Put the battery on the batterymount by aligning the mark, andthen securely plug it in.≥The output plug of the AC cable is notcompletely connected to the AC adaptorjack. As shown in A, there is a gap.ª Charging lampLights up: ChargingGoes off: Charging completedFlashing: Make sure that the terminals of thebattery or the AC adaptor are notexposed to dirt, foreign objects ordust, then reconnect them properly.Disconnect the AC cable from the ACoutlet when you remove dirt, foreignobjects or dust on the terminals of thebattery or the AC adaptor.If the charging lamp is still flashing,something may be wrong with thebattery or AC adaptor. Contact yourdealer.≥Battery charging time (l 32)≥We recommend using Panasonic batteries(VW-VBG260).≥If you use other batteries, we cannot guaranteethe quality of this product.Fitting/Removing the batteryPush the battery against the batteryholder and slide it until it clicks.While sliding the BATT lever, slidethe battery to remove it.≥Hold the battery with your hand so it does notfall.≥Before removing the battery, be sure to set theMode dial to OFF and check that the statusindicator is off.AFitting the batteryRemoving the batteryCAUTIONDanger of explosion if battery is incorrectlyreplaced. Replace only with the same orequivalent type recommended by themanufacturer. Dispose of used batteriesaccording to the manufacturer’s instructions.
