115VQT1A34OthersCautions for use(For Australia)In the event of abnormal operation (e.g. if the unitemits smoke or an unusual smell), immediatelystop operating the unit and consult thePanasonic Customer Care Centre on 132600.The unit and the SD card become warm duringuse. However, this is not a malfunction.Keep the High Definition Video Camera as faraway as possible from electromagneticequipment (such as microwave ovens, TVs,video games etc.).≥If you use the High Definition Video Camera ontop of or near a TV, the pictures and sound onthe High Definition Video Camera may bedisrupted by electromagnetic wave radiation.≥Do not use the High Definition Video Cameranear cell phones because doing so may resultin noise adversely affecting the pictures andsound.≥Recorded data may be damaged, or picturesmay be distorted, by strong magnetic fieldscreated by speakers or large motors.≥Electromagnetic wave radiation generated bymicroprocessors may adversely affect the HighDefinition Video Camera, disturbing thepictures and sound.≥If the High Definition Video Camera isadversely affected by electromagneticequipment and stops functioning properly, turnthe High Definition Video Camera off andremove the battery or disconnect AC adaptor.Then reinsert the battery or reconnect the ACadaptor and turn the High Definition VideoCamera on.Do not use the High Definition Video Cameranear radio transmitters or high-voltage lines.≥If you record near radio transmitters orhigh-voltage lines, the recorded pictures andsound may be adversely affected.Make sure to use the supplied cords andcables. If you use optional accessories, usethe cords and the cables supplied with them.Do not extend the cords and the cables.Do not spray insecticides or volatilechemicals onto the unit.≥If the unit is sprayed with such chemicals, itsbody may be marred and the surface finish maypeel off.≥Do not leave rubber or plastic products incontact with the unit for a long time.When you use the unit in a sandy or dustyplace such as a beach, do not let sand or finedust get into the body and terminals of theunit.Also, keep the unit away from sea water.≥Sand or dust may damage the unit. (Careshould be taken when inserting and removing acard.)≥If sea water splashes onto the unit, wipe off thewater with a well wrung cloth. Then wipe theunit again with a dry cloth.When carrying the unit, do not drop or bumpit.≥A strong impact can break the unit’s casing,causing it to malfunction.Do not use benzine, paint thinner or alcoholfor cleaning the unit.≥Before cleaning, detach the battery or pull outthe AC cable from the AC outlet.≥The camera body may be discoloured and thesurface finish may peel off.≥Wipe the unit with a soft dry cloth to removedust and fingerprints. To remove stubbornstains, thoroughly wring a cloth that has beensoaked in a neutral detergent diluted with waterand wipe the unit with it. Afterwards, wipe itwith a dry cloth.≥When you use a chemical dust cloth, follow theinstructions that came with the cloth.Do not use the unit for surveillance purposesor other business uses.≥If you use the unit for a long time, heat will buildup inside it and this may cause a malfunction.≥This unit is not intended for business use.When you are not going to use the unit for anextended time≥When storing the unit in a cupboard or cabinet,it is recommended that you place a desiccant(silica gel) in with it.About this unit