40VQT3K43The unit is put into recording pause approx. 1 second when the unit is turned on with themode set to or .≥ Depending on the recording conditions, start time may be longer than 1 second.≥ In the quick power on mode, the zoom magnification becomes 1k.This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is reopened.≥ Quick start will not work if there is no SD card inserted.≥ Change the mode to or .1 Set [QUICK START] to [ON].2 Close the LCD monitor while the mode isset to or .The status indicator A flashes green and the unitgoes into quick start standby mode.≥ The lens cover does not close.3 Open the LCD monitor.The status indicator A lights red and the unit isput into recording pause.≥ When in quick start standby mode about 80% of the power used in recording pausemode is being consumed, so the recording time will be reduced.≥ Quick start standby mode is cancelled ifj about 5 minutes elapsedj mode is set to≥ Depending on the recording conditions and menu settings, the time for quick start may belonger than 0.6 seconds.≥ It may take some time for automatic white balance to adjust.≥ In the quick start mode, the zoom magnification becomes 1k.≥ If [ECONOMY] (l 39) is set to [5 MINUTES] and the unit automatically goes into quickstart standby mode, close the LCD monitor and then open it again.≥ Turn the unit off using the power button.≥ Quick start standby mode cannot be released by the remote control.[QUICK POWER ON] [OFF]/[ON][QUICK START] [OFF]/[ON]
