40VQT2N35The unit is put into recording pause approx. 1 second when the power is turned on with themode set to or .≥ Depending on the recording conditions, start time may be longer than 1 second in stillpicture recording mode.≥ In the quick power on mode, the zoom magnification becomes 1k.This unit will resume recording pause mode about 0.6 seconds after the LCD monitor isreopened.≥ Start time will not shorten if there is no SD card inserted.Start time will be shorten if the [Built-inMemory] is selected in the [MEDIA SELECT], even ifthere is no SD card inserted.Start time will be shorten if the [HDD] is selected in the [MEDIA SELECT], even if there isno SD card inserted.≥ Change the mode to or .1 Set [QUICK START] to [ON].2 Close the LCD monitor while the mode is set toor .The status indicator A flashes green and the unit goes intoquick start standby mode.≥ The lens cover does not close.3 Open the LCD monitor.The status indicator A lights red and the unit is put intorecording pause.≥ When in quick start standby mode about 80% of the power used in recording pausemode is being consumed, so the recording time will be reduced.≥ Quick start standby mode is cancelled ifj about 5 minutes elapsedj mode is set to≥ Depending on the recording conditions, time for quick start may be more than 0.6 secondsslower in still picture recording mode.≥ It may take some time for automatic white balance to adjust.≥ In the quick start mode, the zoom magnification becomes 1k.≥ If [ECONOMY] (l 39) is set to [5 MINUTES] and the unit automatically goes into quickstart standby mode, close the LCD monitor and then open it again.≥ Turn the unit off using the power button.[QUICK POWER ON] [OFF]/[ON][QUICK START] [OFF]/[ON]
