Panasonic HomeHawk KX-HN7052C Installation Manual

Also see for HomeHawk KX-HNC715C: Installation guide

Setup overview1 Charging the camerasMake sure the battery is fully chargedbefore you setup the cameras.2 Turning the power on for the camerasTurn the power on.3 Downloading the applicationDownload the [HomeHawk] app to yourmobile device.4 Connection for access pointConnect the AC adaptor and Ethernetcable to the access point.5 Initial setupMake sure you can access the systemusing your mobile device.6 RegistrationRequired only if the camera waspurchased separately (i.e., not as part ofa bundle).7 Confirm the installation areaRead the information in this document toconfirm that the desired installation areais suitable to proper operation.8 InstallationInstall the camera in the desired location.Charging the camerasR This camera has an internal rechargeablebattery.R Remove the camera from the wall beforecharging (page 27).R Make sure to charge the camera indoorsand in a dry location.R Charge the camera in a location with atemperature between 5 °C and 40 °C (41°F and 104 °F). The camera cannot chargein locations outside of these temperatures.Charging the front door cameraCharge for about 7 hours.R Turn the camera off before charging thebattery. If the camera is turned on whilecharging, it may take longer to charge.1 Slide the lock key (A).2 Open the interface cover (B).3 Insert the USB cable into the micro-USBconnector (C).1 233 211Power off25.0 V, 1.0 A or higher power sourceWe recommend using the supplied USB cable.3Charging LED indicatorNote:R Check the charging LED indicatorcontinues to blink in red for more than 10seconds after connecting the USB cable.If the indicator stops blinking and turns offwithin 10 seconds, perform the following.– If you are not using the supplied USBcable, use it.– If the indicator still turns off within 10seconds, try connecting the USB cableFor assistance, visit www.panasonic.ca/english/support 21SetupHN7051C_(en_en)_0319_ver.040.pdf 21 2018/03/19 19:00:12