Panasonic KV-SSM100 Administrator's Manual

Also see for KV-SS1100: User guide Quick setup guide

Panasonic KV-SSM100 Administrator's Manual Manual pdf 50 page image

50KV-SSM100/KV-SS1100 Network Scanner Adapter Administrator’s GuideI. System RecoveryIn the event that Factory Reset does not resolve an issue, it is possible to use the System Restore option, which will do the following:n Erase all settings and all system updates from the device; all data will be lost and cannot be recovered.n Downgrade the unit to the original system version that it was shipped with.n Enable you to reset the administrator password.Note: The Factory Reset option also erases all configuration and plugin settings, but keeps any system updates intact.Important: If you plan to retrieve Logs, do so before applying the recovery procedure; recovery procedure erases the logs.To begin System Restore, proceed with the instructions for your adapter model:KV-SS1100 System Restore:1. If adapter is On, press [Power] button to turn unit Off.2. Connect a USB keyboard to one of the USB ports on the unit.3. Turn adapter On.4. After blue Panasonic screen displays, the message,“Press Alt + F4 to RESTORE ….” will appear. Simultaneouslypress and hold Alt and F4.Note: The key combination will not be recognized if the keyshave been pressed prior to this screen.5. Wait while the device loads into System Restore.Once System Restore has loaded, follow the on-screen instructionsand confirm the dialogs via adapter touch screen.Note: The recovery procedure takes approximately 5 – 10 minutes torestore the unit. Do not power down the unit during this time.6. Once System Restore is complete, confirm the dialog and the systemwill reboot, and various screens will appear. Only operate the deviceafter it finishes the restore process.7. After system reboots, perform Initial Configuration procedure,using either Configure Device Now or Firmware Update.Important: The adapter may display a message to perform systemconfiguration via the Admin Tool web page. If so, open your web browser,enter the adapter's IP address. The default credentials are:- Username: Admin- Password: Panasonic1Note: For more information, see Changing Settings via Admin Tool.