Panasonic KW4M User Manual

11Cutoff current setting mode C U T AMode defines load current that does not measured (Cutoff current).Use to avoid miss-measurement by wiring or induction noise at no-load.0.00kW is displayed for instantaneous electric power, 0.0A is displayed for current. Integratedelectrical energy is not measured.・It can be set the range of 1.0% to 50.0%.ex) When set to 10.0, current under 10.0%F.S is not measured.Unit for pulse output setting mode (Power) P L - PMode defines unit used for pulse output.・Select from 0.001/0.01/0.1/1/10/100kWh /Alarm.When “ALARM” is set, alarm is output at the time when instantaneous electric power is over thesetting value.When one of the “0.001/0.01/0.1/1/10/100”[kWh] is set, one pulse is output at the setting value.Alarm value setting mode A L - PMode defines instantaneous electric power used for alarm output.・It is set the range of 0.00 to 9999.99kW.※This mode is only when “ALARM” is selected on unit for pulse output setting mode.Electricity charge setting mode P Y / $ / E U R / C N Y / C H G / C O 2Mode defines electricity charge ratio and conversion factor used as a standard per 1kWh.The electricity charge ration of 5 kinds of currency (JPY,＄,EUR,CNY,CHG) and CO2 conversionfactor can be set.・It can be set the range of 0.0 to 99.9 yen/1kWh. (Initial 10.0)・It can be set the range of 0.000 to 9.999 dollars/1kWh. (Initial 0.093)・It can be set the range of 0.000 to 9.999 euros/1kWh. (Initial 0.085)・It can be set the range of 0.00 to 99.99 yuan/1kWh. (Initial 10.00）・It can be set the range of 0.00 to 99.99 /1kWh. (Initial 10.00）・CO2 conversion factor can be set the range of 0.000 to 9.999 kg-CO 2 /1kWh. (Initial 0.410）Normal display↓ MODE display↓CT type setting mode Factory setting / Display・Press to change CT type.・CT type is selected from 50→100→250→400→5↓ Primary side current of CT setting mode Factory setting / Display・Enter primary side current of CT using,< A >, < V >.・If measured CT is 100A/5A, set to 100.・If 5A is measured, set to 5.It is only when “5A” is selected on CT type setting mode.↓