KW8M Eco-POWER METER (1A/5ACT input type)12Chapter 4 Settings4.1 Operation procedure【Basic setting to measure】When wiring Eco-POWER METER and CT and setting mode 1 after power on, Eco-POWER Meter canmeasure the electric power. In order to use the other functions, set mode2, 3 and 4 according to youruse.Monitor (Display when power on) Mode 1…Mode for setting each parameter for power measurementSetting mode(Mode 1) (Mode 2) (Mode 3) (Mode 4) Phase/Wire system setting modeSYST Refer to the next page.CT type setting modeCT-TPrimary side current of CTsetting modeCT-1Voltage range setting modeVOLTVT setting modeVTCurrent for time measurementsetting modeHM-ACutoff current setting modeCUTAUnit for pulse output setting modePL-PWhen selectWhen select “AL-P”When select “AL-C”When select “AL-S”When select “Cnt”“Values”Power alarm settingmodeAL-PCurrent alarm settingmodeAL-CStand-by alarm settingmode 1AL-S 1Preset value settingmodeCnt Stand-by alarm settingmode 2AL-S 2Electricity rate setting modeRATE MonitorPress to return Monitor.
