Operating Instructions69Data transfer method:Please use [Passive Mode] normally. If FTP does not work properly,please ask ISP or network administrator about the transferring mode ofFTP server. [Passive Mode] or [Active Mode] is available.b. Mail: Sets the SMTP and POP3 server address*1 or Host Name* 2,Login ID*2 and Password* 2.From (Reply)*3 : Enter the e-mail address of [Reply-to]. [To] can be thesame address as From (Reply).To * 3: Enter the e-mail address of receiver.Subject & Text *4 : Sets the subject and text of the e-mail.Time in 24 h mode is attached on the subject.Notes• Please set POP3 server address or Host Name, Login ID andPassword if you need POP authentication to send the e-mail.Please ask ISP or administrator.• The Network Camera will only operate correctly with SMTP (SimpleMail Transfer Protocol) server. It is not available with the Internetaccessed mail server like "Hotmail" or others accessed via the webbrowser.c. Selects [No Message] or [Mail]Mail: Only the notification e-mail is sent when the alarm trigger isactive. Please refer to b. Mail for each parameter.*1 Please refer to IP addressing on Page 92.*2 Please refer to unavailable character set 1 on Page 92.*3 Please refer to unavailable character set 2 on Page 92.*4 Only ["] is unavailable in the ASCII character table on Page 92and please refer to displayable character set on Page 93.2. Select/Enter the each parameter. Click [Save] when finishing.• Click [Cancel] to quit the current settings. It returns to the Setup Pagewithout saving the parameters.• Click [Clear Buffered images] to clear the buffered image.[Clear Buffered images] does not save the parameters.