Panasonic KX-HNC600 Installation Manual

Also see for KX-HNC600: Quick setup User guide Installation guide Installation guide

Contents

Panasonic KX-HNC600 Installation Manual Manual pdf 17 page image

InstallationInstallation precautionsR Do not install the camera on a ceiling.R Holes must be made in the wall for cablesand wires to pass through. Panasonic takesno responsibility for issues related toopening holes in walls.R Make sure to waterproof the holes youmake in the wall.R Make sure you attach the safety wire toprevent the camera from falling.R Do not use an impact driver. (This may leadto damaged screws or over-tightening.)R Mount the camera on the stable locationwhere the unit can be adequatelysupported when installing.R The AC adaptor should be connected to avertically oriented or floor-mounted ACoutlet. Do not connect the AC adaptor to aceiling-mounted AC outlet, as the weight ofthe adaptor may cause it to becomedisconnected.R Do not mount the camera on a softmaterial. It may fall down, break or causeinjury.Wall material informationSidingR Use the included screws ø4 mm ´ 25 mm(ø5/32 inches ´ 1 inch). Make sure thepull-out capacity of each screw is at least294 N (30 kgf).R If the weight of the camera is supported bythe siding only, the siding could becomedamaged. Make sure you mount thecamera in a location where the structurebehind the siding can be used to supportthe weight of the camera. If this is notpossible due to the thickness of the siding,use commercially-available screws ø4 mm´ longer than 25 mm (ø5/32 inches ´ longerthan 1 inch).R Drill a pilot hole using a drill bit that isappropriate for the type of siding. Removeany debris after drilling the pilot hole. Donot drill the pilot hole into the structurebehind the siding.Poor exampleNo support behind exterior surface211Siding2Open space, no supportFor assistance, please visit http://shop.panasonic.com/support 17SetupHNC600_(en_en)_0123_ver.201.pdf 17 2017/01/26 9:24:43