Panasonic KX-HNS104 Installation Manual

Also see for KX-HNS104: User guide Installation guide

Contents

Panasonic KX-HNS104 Installation Manual Manual pdf 10 page image

Using registration buttons1 Hub:Press and hold M OTHERDEVICEN until the LED indicatorblinks in green.2 Sensor:Press and hold M N until theLED indicator blinks in green(page 8).R When registration is complete,the hub sounds one long beep.Note:R To cancel the registration, pressM N on the hub and on the sensor.R If registration fails, the hub soundsseveral short beeps.Using the appWhen you register the sensor by usingthe [Home Network] app, you canassign a name to your devices andgroup them by location. For moreinformation, refer to the User’s Guide(page 14).Information aboutsensor featuresPlease read the following informationbefore deciding where to install thesensor.Note:R The sensor’s features are notdesigned to be used in situationsthat require high reliability. We donot recommend use of the sensor’sfeatures in these situations.R Panasonic takes no responsibility forany injury or damage caused by theuse of the sensor.Glass break sound detectionThe sensor uses a microphone todetect the unique sound frequenciesthat are produced when glass breaks.1Sensor detection range (when set toMHIGHN):1: approx. 5 m (16.4 feet)Note:R The sensor may make falsedetections when there is noise frommetallic blinds opening and closing,metallic bells of alarm clocks, etc.Applicable glass specificationsType Thicknessxxxx Minimum: xx mm(xx inches)Maximum: xx mm(xx inches)xxxx Minimum: xx mm(xx inches)Maximum: xx mm(xx inches)10 For assistance, please visit www.panasonic.com/supportSetupHNS104_(en_en)_1120_ver.010.pdf 10 2014/11/19 19:59:09