5.6.3 Programming the Network SettingsFor successful operation of a VoIP network using the V-IPGW16 card, network settings for the PBX at eachlocation must be programmed appropriately. For a detailed discussion of related features, refer to the FeatureGuide.This section details the procedure to programme the network settings for the local PBX. After the programmingfor the local PBX has been done, repeat the procedure for the remote PBX with the appropriate setting values.The following procedures describe the process of programming the network settings for each numberingmethod.Programming for the PBX Code Method1. a. Click Setup ® PBX Configuration ®Configuration ® Slot.b. Click Virtual ® V-IPGW16.c. Move the mouse pointer over the installedV-IPGW16 card to display the menu of options, andclick Ous (out of service) to set the card to out ofservice.d. Repeat step c for each installed V-IPGW16 card untilall V-IPGW16 cards are OUS.e. Move the mouse pointer over the installedV-IPGW16 card to display the menu of options, andclick Port Property.Confirm that all V-IPGW16 cards are OUS.NoteWhen a V-IPGW16 card is installed, 8 ports areavailable for the card (a port has 2 channels).2. a. Click Setup ® PBX Configuration ® CO &Incoming Call.b. Click CO Line Settings.c. Type the CO Name and assign an unused TrunkGroup Number to be used for all IP trunks.d. Click OK.156 Installation Manual5.6.3 Programming the Network Settings
