• When using VPSS, opposing subnets of KX-NS1000 PBXs are automatically configured. However,subnets created by subsequent external routers are not taken into account.• In routing settings for crossing subnets, a maximum of 4 network addresses for adjacent segments, satelliteoffices, etc., can be configured for each site. These settings are configured in the VPSS Advanced Settings.PC Programming Manual References27.9 Router Configuration—VPN—[3-1] VPSS8.6.25 Router CommandDescriptionYou can enter router commands from Web Maintenance Console. You can reference the built-in router’ssettings in the commands’ results.The following commands are available.Command DescriptionROUTE Display the connected route information cache.NETSTAT Display the status for each interface.ARP Display the ARP table state.DNSFLUSH Clear the DNS cache.Conditions• Users with User (Admin) privileges or higher can access this feature.PC Programming Manual References7.8.2 Utility—Command—Router Command8.6.26 WAN Port MirroringDescriptionThis feature mirrors the contents of packets sent and received on the WAN interface on the MNT port. WithWAN port mirroring, you can analyse the contents of packets that pass through the WAN port.You can enable/disable WAN port mirroring.Conditions• Users with User (Admin) privileges or higher can access this feature.PC Programming Manual References28.1 Network Service—[1] IP Address/Ports—Advanced Settings— Port Mirroring—Packet kind for mirroring368 Installation Manual8.6.26 WAN Port Mirroring
