5.5 Programming a One-look NetworkThe Add Site Wizard, which is run from the Home Screen of the Master unit, will add other KX-NS series PBXsconnected to the private IP network to your One-look network as Slave units.NoticeWhen using a One-look network, do not disable the PBX’s FTP server settings. For details, refer to"28.2.2 Network Service—[2-2] Server Feature—FTP" in the PC Programming Manual.NoteThe PBX to be added must have been configured as a Slave unit using the Easy Setup Wizard.For details about Easy Setup Wizard, see "5.4.1 Easy Setup Wizard".1. To start the Add Site Wizard, click the Add Slave button( ) on the Home screen.2. Follow the prompts of the Add Site Wizard to completefollowing settings:• PBX Setting• WAN Setting• Registration Setting• SNTP / Daylight Saving• Maintenance SettingNote• The parameters which appear in the settingsabove are described in "5.4.1 Easy SetupWizard".• If 2 or more sites will be added to the One-looknetwork, repeat steps 1 to 2 for each site.3. After the Add Site Wizard is completed, click on theHome screen, and then click Registration on the ListView.4. A list of KX-NS series PBXs set up as Slave units will bedisplayed under Available Site.Select PBXs by their assigned site names and click theright arrow to move them to Selected Site forRegistration.Click Next to start the registration process.5. On the Registration screen, the status of PBXs beingregistered is displayed.6. On the Registration screen, the result of the registrationprocess is shown. Click Close to continue.Registered Slave PBXs can now be viewed and selected on the Home Screen for programming.MASTER LED TransitionWhen adding Slave units, the MASTER LED of each KX-NS1000 PBX changes as shown in the following table:Installation Manual 2295.5 Programming a One-look Network
