• On or near computers, or other office equipment, as well as microwave ovens or air conditioners. (It ispreferable not to install the system in the same room as the above equipment.)• Within 1.8 m of radios and televisions. (Both the PBX and PTs should be at least 1.8 m away from suchdevices.)Do not perform the following:• Do not block the openings of the PBX.• Do not stack up the optional service cards.Wiring PrecautionsBe sure to follow these instructions when wiring the unit:CAUTION• Avoid using the same AC outlet for computers and other office equipment, as noise generated by suchequipment may hamper system performance or interrupt the system.• Unplug the system from its power source when wiring, and plug the system back in only after all wiringis completed.• Trunks should be installed with surge protectors. For details, refer to "4.2.11 Surge ProtectorInstallation".Notice• Use 1-pair telephone cables when connecting SLTs, data terminals, answering machines, computers,etc.• Mis-wiring may cause the PBX to operate improperly. Refer to "Section 4 Installation" when wiringthe system.• If an extension does not operate properly, disconnect the telephone from the extension line and connectit again, or turn off the PBX using the power switch, then turn it on again.• Use twisted pair cable for trunk connection.• To prevent signal noise from interfering with the performance of the product, do not run unshieldedtelephone cables near AC power cables, computer cables, AC power sources, etc. When runningcables near other noise-generating devices or cables, use shielded telephone cables or shield thetelephone cables with metal tubing.Preparing the Network EnvironmentBe sure to prepare your network’s environment for the installation of the PBX according to the intended PBXnetworking configuration. For details about PBX network configurations, refer to "Section 8 NetworkingInformation".Installation Manual 814.1.1 Before Installation
