Panasonic KX-NS8290 Installation Manual

Panasonic KX-NS8290 Installation Manual Manual pdf 27 page image

3.2.4 Types of ConnectorsPlease refer to "Types of Connectors" in the Installation Manual of the KX-NS1000 PBX. The connector typefor the Trunk Adaptor is RJ45.3.2.5 Placing the Trunk Adaptor on a DesktopWhen placing the Trunk Adaptor on a desktop, make sure to follow these instructions.WARNINGBe careful not to drop any components. Dropping components may damage them or cause aninjury.CAUTION• When the Trunk Adaptor is placed on a desktop, make sure that it is placed as indicated in the diagrambelow. Do not place it on its side or upside down.Desk or Table• When placing the Trunk Adaptor on a desktop, be sure to run the cables on the side of the TrunkAdaptor. Do not run the cables on top or under it. The following illustrations are bad examples of cablewiring.3.2.6 Wall MountingThe Trunk Adaptor can be mounted on a concrete wall using the wall-mounting equipment (screws, washers).WARNING• Make sure that the wall that the Trunk Adaptor will be attached to is strong enough to supportthe Trunk Adaptor (approx. 500 g). If not, it is necessary for the wall to be reinforced.Installation Manual 273.2.6 Wall Mounting