Problem Cause/solutionTime on the unit hasshifted.R Incorrect time information from incoming Caller ID changes thetime. Set the time adjustment to “Manual” (off) (page 23).SMS (Short Message Service)Problem Cause/solutionThe SMS messagecentre number is loggedin the caller list and themessage is not received.R Someone tried to send you a message while SMS is turned off.Turn it on (page 37).I cannot send or receiveSMS messages.R You have not subscribed to the appropriate service. Contactyour service provider/telephone company.R The SMS message centre number(s) are not stored or areincorrect. Store the correct numbers (page 37).R Message transmission was interrupted. Wait until the messagehas been sent before using other telephone functions.R If you use a DSL/ADSL service, we recommend connecting aDSL/ADSL filter between the base unit and the telephone linejack. Contact your DSL/ADSL provider for details.“FD” is displayed. R The unit could not connect to the SMS message centre.Confirm that the correct SMS message centre numbers arestored. Confirm that SMS is turned on (page 37).“FE” is displayed. R An error occurred while sending the message. Try again.“E0” is displayed. R Your phone number is permanently withheld or you have notsubscribed to the appropriate service. Contact your serviceprovider/telephone company.Liquid damageProblem Cause/solutionLiquid or other form ofmoisture has entered thehandset/base unit.R Disconnect the AC adaptor and telephone line cord from thebase unit. Remove the batteries from the handset and leave todry for at least 3 days. After the handset/base unit arecompletely dry, reconnect the AC adaptor and telephone linecord. Insert the batteries and charge fully before use. If the unitdoes not work properly, contact an authorised service centre.Caution:R To avoid permanent damage, do not use a microwave oven to speed up the drying process.49Useful InformationPRW110FX(en)_0724_ver012.pdf 49 2013/07/24 13:40:28