General Programming Instructions16 Programming Guide1.5 User Programming ModeUser Programming ModeSome programming items are accessible by any display proprietary telephone user in thesystem.The programming items are listed below:[000] Date and Time Set[001] System Speed Dialing Number Set[003] Extension Number Set[004] Extension Name Set[005] Flexible CO Button Assignment[006] Operator / Manager Extension Assignment[007] DSS Console Port and Paired Telephone Assignment[008] Absent Messages[009] Quick Dial Number Set[014] VM Name Set[017] DISA User CodesEntering the user programming modeYou can access these programs by entering the User Programming Mode as follows:Before entering the mode, confirm that:• Your telephone is on-hook.• No calls are on hold at your telephoneAfter entering the mode, perform the same programming steps as the system programmingsteps in each program address.Note• If nothing is entered in five seconds after the PAUSE button is pressed, it is canceled.• The User Password is not shown on the display. The password can be changed by systemprogramming. Refer to Section [120] User Password.• During the programming mode, your extension is treated as a busy extension.• Only one proprietary telephone can be in programming mode at any one time.Press PAUSE + + and enter the User Password(default: 1234)
