General Programming54 Programming Guide[110] Caller ID Code SetDescriptionSets the identification code of the calling party (Caller ID Code) to utilize a Caller ID Serviceprovided by a specific central office (CO). If an ID Code transmitted from the CO is found inthe Caller ID Code Table, the caller's ID Code or name given to the code in program[111] Caller ID Name Set is displayed on the telephone. This allows the called party torecognize the caller.Selection• Location number: 001 through 500• Caller ID Code: 24 digits (max.)DefaultAll locations — Not storedProgramming1. Enter 110.Display: 110 CALLER ID #2. Press NEXT.Display: Location NO?3. Enter a location number.To enter location number 001, you can also press NEXT.Display example: 001:Not Stored4. Enter a Caller ID Code.To delete the current entry, press CLEAR.To change the current entry, press CLEAR and enter the new code.5. Press STORE.6. To program another location, press NEXT or PREV, or SELECT and the desired locationnumber.7. Repeat steps 4 through 6.8. Press END.Conditions• Each Caller ID Code has a maximum of 24 digits, consisting of 0 through 9.• Program [111] Caller ID Name Set is used to give names to the Caller ID Codes. If an IDCode is assigned a name, the called party's telephone will show the name in place of the IDCode.
