Panasonic KX-TC1486 Operating Instructions Manual

Troubleshooting “31Useful InformationFor assistance, please call: 1-800-211-PANA(7262)ProblemThe unit does not work.An alarm tone sounds.Static, sound cuts in/out,fades. Interference fromother electrical units.The handset does not ring.The handset display isblank.You cannot program items,such as the dialing mode.Cause and Remedy≥Check the settings (p. 7–9).≥Charge the battery fully (p. 8).≥Clean the charge contacts and chargeagain (p. 9).≥Check battery installation (p. 8, 30).≥Place the handset on the base unit andunplug the AC adaptor to reset. Plug in,and try again.≥You are too far from the base unit.Move closer and try again.≥Place the handset on the base unit andtry again.≥Plug in the AC adaptor.≥Raise the base unit antenna.≥Locate the handset and the base unitaway from other electrical appliances(p. 3).≥Move closer to the base unit.≥Raise the base unit antenna.≥Press [CH/FUNCTION] to select aclearer channel in the talk mode.≥The ringer volume is set to OFF. Set toON (p. 9).≥If a power failure occurs, the handsetloses communication with the base.When power returns, place the handseton the base unit once then try again.≥Install the battery properly (p. 8, 30).≥Charge the battery fully (p. 8).≥Programming is not possible while theunit is in the talk mode or when viewingthe Caller List/phone book.≥Do not pause for over 60 seconds whileprogramming.≥Move closer to the base unit.≥ or may have been pressedwhen you picked up the handset. Press[OFF] and try again.≥Lift the handset off the base unit and tryagain.[ ][ ]