Panasonic KX-TCD200E Operating Instructions Manual

Handset Settings20 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333before you answer. You may hear a dialtone or no one on the line when youanswer a call.L The preset melodies in this product areused with permission of © 2004 M-ZoNECo., Ltd.Night modeNight mode allows you to select a block oftime during which the handset will not ringfor outside calls. This feature is useful fortimes when you do not want to be disturbed,for example, while sleeping. Night mode canbe set independently for the handset and thebase unit (page 25).Using the phonebook’s category feature(page 15), you can also select categories ofcallers whose calls will override night modeand ring the handset (Caller ID subscribersonly).Set the date and time beforehand (page 10).Setting the start and end time for nightmode1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Ringer Setup”, then press{>}.4 Select “Night Mode”, then press {>}.5 Select “Start/End”, then press {>}.6 Enter the desired hour and minute youwish to start this feature by selecting 2digits for each.L If you use 12-hour time entry, select“AM” or “PM” by pressing {*}repeatedly before entering the time.7 Enter the desired hour and minute youwish to end this feature by selecting 2digits for each.L If you use 12-hour time entry, select“AM” or “PM” by pressing {*}repeatedly before entering the time.8 Press {j/OK}.9 Press {ih}.Turning night mode on/off1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Ringer Setup”, then press{>}.4 Select “Night Mode”, then press {>}.5 Select “On/Off”, then press {>}.6 Select “On” or “Off”, then press {>}.7 Press {ih}.Note:L When the night mode is turned on, “[N]”is displayed.Setting the ring delay for night modeThis setting allows the handset to ring duringnight mode if the caller waits long enough.After the selected amount of time passes,the handset will ring, useful when someoneurgently needs to speak with you. If youselect “No Ringing”, the handset will notring during night mode.1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Ringer Setup”, then press{>}.4 Select “Night Mode”, then press {>}.5 Select “Ring Delay”, then press {>}.6 Select the desired setting, then press{>}.7 Press {ih}.TCD200E(e-e).book Page 20 Wednesday, February 9, 2005 2:58 PM