Panasonic KX-TCD200G Operating Instructions Manual

Base Unit Settings24L If the location already contains a carriercode, the code is displayed.9 Enter the carrier code (7 digits max.), thenpress {j/OK}.10 Press {ih}.Storing area codes for ARSStore the area codes which should be dialledusing a specific carrier. You can store up to 25area codes.1 Press {j/OK}.2 Select “Basis-Einstell.”, then press{>}.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (Seite 25).4 Select “Rufoptionen”, then press {>}.5 Select “Tarifmanager”, then press {>}.6 Select “Vorwahlnr.”, then press {>}.7 Select an area code location (1 to 25), thenpress {>}.L If the location already contains an areacode, the code is displayed.8 Enter an area code (5 digits max.), thenpress {j/OK}.9 Select a carrier code you stored (C1 to C5)earlier, then press {>}.L This carrier code will be automaticallydialled when you make a call to this areacode.10 Press {ih}.Turning ARS off1 Press {j/OK}.2 Select “Basis-Einstell.”, then press{>}.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (Seite 25).4 Select “Rufoptionen”, then press {>}.5 Select “Tarifmanager”, then press {>}.6 Select “Netzbetreiber”, then press {>}.7 Select “Aus”, then press {>}.8 Press {ih}.Setting call restrictionYou can restrict selected handsets from diallingcertain numbers. You can assign up to 6 phonenumbers to be restricted, and select whichhandsets will be restricted. Storing area codeshere will prevent the restricted handsets fromdialling any phone number in that area code. If arestricted number is dialled, the call will not beconnected and the restricted number will flash onthe display.1 Press {j/OK}.2 Select “Basis-Einstell.”, then press{>}.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (Seite 25).4 Select “Rufoptionen”, then press {>}.5 Select “Wahlsperre”, then press {>}.6 Set which handsets will be restricted bypressing the desired handset number.L All the registered handset numbers will bedisplayed.L Flashing numbers indicate call restrictionis turned on for the corresponding handset.L To turn call restriction off for a handset,press the number again. The number willstop flashing.7 Press {j/OK}.8 Select a memory location, then press {>}.L If the memory location already contains arestricted number, the number isdisplayed.9 Enter the phone number or area code to berestricted (8 digits max.), then press{j/OK}.L To erase a restricted number, press{C/T}.10 Press {ih}.TCD200G(e-g).book Page 24 Tuesday, February 8, 2005 8:57 AM