2.8 System Restart112 General Installation2.8 System Restart2.8.1 System RestartAfter starting the system, if the system does not operate properly, restart the system.Before restarting the system, try the system feature again to confirm whether there definitelyis a problem or not.System Restart causes the following:a) Camp-on is cleared.b) Calls on Hold are terminated.c) Calls on Exclusive Hold are terminated.d) Calls in progress are terminated.e) Call Park is cleared.Other data is not cleared by System Restart.1. Make sure that the System Clear Switch is set to the "NORMAL" position.2. Press the Reset Button with a pointed tool.NoticeAfter pressing the Reset Button, if you notice that the System Clear Switch is set to the"CLEAR" position, never slide the System Clear Switch to the "NORMAL" position within 20seconds. Otherwise, all the system programming data are reset to default values (Refer toSection 2.9.1 System Data Clear). Wait at least 30 seconds, then slide to the "NORMAL"position. Then the system will work as before.If the system still does not operate properly, please see Section 6.1.4 Using the Reset Button.