6-F-2OperationExecuting Automatic Hold by pressing theANSWER key or the LOOP keyDuring a conversation with a CO call or anextension on the SRC side of the LOOP key,another call arrives on another LOOP key.Press the ANSWER key, or theLOOP key where the call isarriving.• The first call is held, and theSRC indicator starts to flash ingreen 60 wink.• The SRC indicator of the LOOPkey where call is arriving lights.• Speak to the second party.(Supplement)Executing Automatic Hold without pressing theANSWER key or the LOOP keyWhile in a conversation with an outside party orextension on SRC side of a LOOP key, executeany of the following operations on DES side ofthe LOOP key, then the current call is heldautomatically.• Using dial pad• Pressing the CALL PARK key (programmablekey)• Pressing the SERIAL key (programmable key)—Only during a conversation with a CO call.• Pressing the TOLL CHG key (programmablekey)—Only during a conversation with an extension• Pressing the AUTO key (programmable key)• Pressing the PAGE key• Pressing the TRG key (programmable key)• Pressing the One Touch key (programmablekey)LOOP2.00 Automatic HoldDescriptionMaking a call during a conversation with an outsideor extension party causes holding the currentconversation automatically, and performs callingon the DES side.Another call arriving during the conversation canbe answered by pressing the ANSWER key or theLOOP key, holding the current party automatically,if “Automatic Hold” is set to “Yes” in the AttendantManagement screen.To answer the new call by holding or disconnectingthe current call can be assigned by programming.Music on Hold is sent to the held party if available.For sending Music on Hold, prior assignment isnecessary by programming. Refer to Section 3-E-1.00 “Music on Hold”.ProgrammingConditionsNoneAttendant Management Reference6-C-10.00Automatic Hold