Panasonic KX-TG1810NZ Operating Instructions Manual

Panasonic KX-TG1810NZ Operating Instructions Manual Manual pdf 34 page image

Multi-unit Operation34Cancelling a base unitA handset can be registered to a maximumof 4 base units. A handset can cancel a baseunit that it is registered to. This allows thehandset to “forget” the base unit.1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Registration”, then press{>}.4 Enter “335”.5 Select “Cancel Base”, then press{>}.6 Enter “0000” (default handset PIN).L If you changed the PIN, enter it (page22).7 Select the base unit(s) you want tocancel, by pressing the desired base unitnumber.L The selected base unit number(s) willflash.L To cancel a selected base unitnumber, press the number again. Thenumber will stop flashing.8 Press {j/OK}.9 Select “Yes”, then press {>}.10 Press {ih}.Note:L To register the handset to another baseunit or to the same base unit again, seemanual registration (page 33).Increasing the range of the baseunitYou can increase the range of the base unitby using a DECT repeater. Please use onlythe Panasonic DECT repeater noted onpage 5. Consult your Panasonic dealer fordetails.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.Turning the repeater mode on/off1 Press {j/OK}.2 Select “Base Unit Setup”, thenpress {>}.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page28).4 Select “Other Options”, then press{>}.5 Select “Repeater Mode”, then press{>}.6 Select “On” or “Off”, then press {>}.7 Press {ih}.Note:L After turning repeater mode on/off, youwill not be able to make or receive calls fora few moments.Intercom betweenhandsetsIntercom calls can be made betweenhandsets in the same radio cell, but notbetween handsets in different radio cells.Example: When handset 1 calls handset 21 Handset 1:Press {INT} and {2} (desired handsetnumber).2 Handset 2:Press {C} or {s} to answer.3 When finished talking, press {ih}.