Panasonic KX-TG2346 Operating Instructions Manual

Contents

For assistance, please call: 1-800-211-PANA(7262) 51Listening to MessagesAnswering SystemUsing the Handset (Remote Operation)If “New message” is displayed on the handset, new messages have beenrecorded.• If the Message Alert is turned on (p. 24), the Ringer/Message Alert indicator onthe handset will flash slowly when new messages have been recorded and thehandset is not in use.To play back messages• If a call is received during playback, the unit rings and playback stops. To answerthe call, press [C] or [s]. For playback, start again from the beginning afterhanging up.• At the end of the last message, “End of final message” is heard. The unit willannounce the remaining recording time if it is less than 3 minutes.• If you hear “Memory full” after playback, erase unnecessary messages (p. 53).• When memo messages are played (p. 54), “MEMO” is displayed.Voice menuIf you do not press any buttons at the end of the last message, the unit willannounce “End of final message” and the voice menu will begin.The unit announces, “Press 4 to play back new messages. Press 5 to play back allmessages.”• You can press buttons for other playback options (p. 52) even if the voice menuhas started.• If you do not press any button within 10 seconds after the voice menu, thehandset will exit remote operation.1 Press [MENU].2 Press Select at “Message play”.• The unit announces the number of new messagesand only new messages are played back from thespeaker. To switch to the receiver, press [C]. Toswitch back to the speaker, press [s].• When you have no new messages, the unitannounces “No new messages. All message playback”and plays back all messages.• When you have no messages, the unit announces“No messages”.• To play all messages, press [5].• If you do not press any button, the voice menu willstart (see below).3 To end remote operation, press [OFF].HandsetMessage playBack SelectK dB LMENU=Call back@4 =Erase msgRepeat SkipK L