Useful InformationFor assistance, please call: 1-800-211-PANA(7262) 65TroubleshootingIf the handset display shows error messages, see “If the Following Appear onYour Display...” (p. 64) for the Cause & Remedy.Telephone SystemProblem Cause & Remedy“No link to base. Movecloser to base, tryagain.” is displayed and analarm tone sounds.• You are too far from the base unit. Walkcloser to the base unit.• Confirm the base unit’s AC adaptor isplugged in.• Raise the base unit antenna.• If the above remedies do not solve theproblem, the handset may have lostcommunication with the base unit. Registerthe handset again (p. 47).Static, sound cuts in/out,fades. Interference from otherelectrical units.• Move the handset and base unit away fromother electrical appliances (p. 3).• Walk closer to the base unit.• Raise the base unit antenna.The handset and/or base unitdoes not ring.• The ringer volume is turned off. Set to high,medium, or low (p. 17, 18).The handset display is blank. • If only the handset display is blank, fullycharge the battery (p. 10).You cannot program anyfunction items.• Programming is not possible while thehandset and/or base unit is being used.• Do not pause for over 60 seconds whileprogramming.• Walk closer to the base unit.• While another user is listening to messagesor the Answering System is handling a call,you cannot program. Try again later.While programming orsearching, the handset startsto ring and the program/search stops.• A call is coming in. To answer the call, press[C] or [s]. Start again from the beginningafter hanging up.You cannot make an intercom/outside call.• Your handset is in remote operation mode(p. 51). Exit by pressing [OFF].• If the handset or base unit is in use, you maynot be able to make a call. Try again later.