Panasonic KX-TG2721AL Operating Instructions Manual

Also see for KX-TG2721AL: Operating instructions

Panasonic KX-TG2721AL Operating Instructions Manual Manual pdf 34 page image

Error messagesDisplay message Cause/solutionError R Recording was too short. Try again.Failed R Phonebook copy failed (page 16). Confirm the other handset(the receiver) is in standby mode and try again.Incomplete R The receiver’s phonebook memory is full. Erase the unwantedphonebook entries from the other handset (the receiver) andtry again.Memory Full R The phonebook memory is full. Erase unwanted entries(page 16).Messages Full R Message memory is full. Erase unwanted messages(page 25, 26).No link to base.Reconnect ACadaptor.R The handset has lost communication with the base unit. Movecloser to the base unit and try again.R Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.R The handset’s registration may have been cancelled.Re-register the handset (page 38).TroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the base unit’sAC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on thehandset.General useProblem Cause/solutionThe handset does not turnon even after installingcharged batteries.R Place the handset on the base unit or charger to turn on thehandset.The unit does not work. R Make sure the batteries are installed correctly (page 9).R Fully charge the batteries (page 9).R Check the connections (page 9).R Unplug the base unit’s AC adaptor to reset the unit and turnoff the handset. Reconnect the adaptor, turn on the handsetand try again.R The handset has not been registered to the base unit.Register the handset (page 38).The handset display isblank.R The handset is not turned on. Turn the power on (page 12).34Useful Information